Installation Guide

9
Install Oven
1. Using two or more people, lift the oven partially into the
cabinet cutout. Use the oven opening as an area to grip.
NOTE: When pushing the microwave oven into the cabinet,
open the microwave oven door and push against the seal
area on the front frame. Do not push against the outside
edges.
2. Push against the front frame of the microwave oven to push
oven into cabinet.
3. Push oven completely into the cabinet and center the oven
into the cabinet cutout.
4. Remove the tape from the black front trims and remove the
zip tie from the mounting spacer.
■ Securely fasten the oven to the cabinet using the
#8-14 x 3/4" (1.9 cm) screws provided.
■ Insert the screws through holes in black trim aligning with
holes in oven frame and mounting spacer already in place.
Install Deector Kit Bracket
This assembly is required for use when a single or double built-in
oven is installed in a ush installation
1. Flex the upper vent piece (C) away from the lower vent
piece (D) to slide the deector bracket (B) between them.
Some force may be required to ex the upper vent trim (C)
away from the lower vent trim (D). Some force may also
be required to ex the deector bracket (B) and slide it
into position. Make sure screw holes are properly aligned
between the two pieces. See the following illustration.
2. Install the deector bracket (B) to the lower vent piece (D)
using two #8-18 x 1/4" (6.3 mm) screws on each side.
NOTE: On 27" (68.6 cm) models, only one #8-18 x 1/4"
(6.3 mm) screw is used on each side.
3. Align vent tab (B) with oven frame (A) as shown in the
following illustration.
4. Using one #8-18 x 3/8" (9.5 mm) screw (E) on each side of
the vent tab (B), fasten the vent securely to the oven.
A. Oven Frame
B. Mounting spacer
C. Oven frame hole
D. Black trim piece
A
C
D
B
B
A. #8-18 x 1/4" (6.3 mm) screws
B. Deflector bracket
C. Upper vent piece
(supplied with oven)
D. Lower vent piece
(supplied with oven)
D
B
A
C
B
D
C
A. Oven frame
B. Vent tab
C. Oven vent
D. Deflector bracket
E. #8-18 x 3/8" (9.5 mm)
screw
A
C
D
B
E
06-May-2019 13:38:41 EDT | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")