Flush Installation Instructions

4
INSTALLATION INSTRUCTIONS
Prepare Built-In Microwave/Oven
Combination
NOTES:
■ Refer to the following “Installation Instructions” and
the “Installation Instructions” section of the Installation
Instructions provided with your built-in microwave/
oven combination.
■ Refer and adhere to the “Electrical Requirements” section
and complete the instructions in the “Make Electrical
Connection” section of the Installation Instructions
provided with your built-in microwave/oven combination.
1. Decide on the nal location for the oven. Avoid drilling or
cutting into house wiring during installation.
2. To avoid oor damage, set the oven on cardboard prior to
installation. Do not use the handle or any portion of the
front frame for lifting.
3. Remove the shipping materials and tape from the oven.
Remember to keep the corner posts and other materials
that may be needed for installation.
4. Remove the hardware package from inside the bag
containing literature.
5. Move oven and cardboard close to the oven’s nal location.
Remove Oven Door
IMPORTANT: Use two hands to remove the oven door.
1. Prior to removing the oven door, prepare a surface where
you will place it. This surface should be at and covered
with a soft blanket, or use the corner posts from your
packaging material.
2. Fully open the oven door.
A. Oven door hinge lock in
locked position
B. Oven door hinge lock in
partially unlocked position
4. Gently start to close the door. The door will stop at a
partially closed position.
5. Using two hands, grasp the edges of the oven door.
Close the oven door slightly past the stop position
to take the weight off of the door hinges, and then
pull the oven door up.
WARNING
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
3. Locate the oven door hinge locks in both corners of the
oven door, and rotate the hinge locks toward the oven
door to the unlocked position. If the door hinge lock is not
rotated fully (see illustration B), the door will not remove
properly.
Door
Hinges
Locked
position
Grip here
to rotate
Unlocked
position