Installation Instruction

15
Install Warming Drawer Deflector
Kit (Only for Ovens Installed
Above Warming Drawers)
On single and double oven models installed above a warming
drawer, a warming drawer deector kit must be installed. See the
“Tools and Parts” section for information on ordering.
Parts Supplied in Deector Kit
Install Deector Kit
1. Flex the upper vent piece (C) away from the lower vent piece
(D) to slide the warming drawer deector (B) between them.
Some force may be required to ex the upper vent trim (C)
away from the lower vent trim (D). Some force may also be
required to ex the warming drawer deector (B) and slide
it into position. Make sure screw holes are properly aligned
between the two pieces. See the following illustration.
2. Install the warming drawer deector (B) to the lower vent
piece (D) using two #8-18 x 1/4" (6.6 mm) screws on each
side.
3. Align vent tab (B) with oven frame (A) as shown in the
following illustration.
4. Using one #8-18 x 3/8" (9.5 mm) screw (E) on each side of
the vent tab (B), fasten the vent securely to the oven.
Complete Installation
1. Check that all parts are now installed. If there is an extra
part, go back through the steps to see which step was
skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. For oven use and cleaning, read the Use and Care Guide.
Check Operation of Single and Double Ovens
1. Turn on power.
2. At rst use, set up the clock and any other preferences
if available. For more information, read the Use and
Care Guide.
3. Press BROIL on single oven models.
NOTE: Press UPPER BROIL or LOWER BROIL
on double oven models.
4. Set the temperature.
5. Press START.
If Oven(s) Does Not Operate, Check the Following:
■ Household fuse is intact and tight, or circuit breaker
has not tripped.
■ Electrical supply is connected.
■ See “Troubleshooting” section in the Use and Care
Guide.
6. When oven has been on for 5 minutes, feel for heat.
If you do not feel heat or if an error message appears in the
display, turn off the oven and contact a qualied technician.
7. Press UPPER CANCEL/LOWER CANCEL on double ovens,
or press CANCEL on single ovens.
If You Need Assistance or Service:
Please refer to the “Warranty.”
B
A
A. Phillips head screws (4)
B. Warming drawer deector (1)
D
B
A
C
B
D
C
A. #8-18 x 1/4" (6.6 mm) screws
B. Warming drawer deector
C. Upper vent piece
D. Lower vent piece
A
C
D
B
E
A. Oven frame
B. Vent tab
C. Oven vent
D. Warming drawer deector
E. #8-18 x 3/8" (9.5 mm) screw