Instructions

7
High Altitude Conversions
IMPORTANT: You must convert Propane gas with Propane
gas High Altitude Kit Part Number W11035431 or Natural gas
with Natural gas High Altitude Kit Part Number W11035432. If
you need to convert Propane gas to Natural gas high altitude
or Natural gas to Propane gas high altitude, you must convert
the pressure regulator. For this, follow steps 1 through 3 of the
necessary conversion.
Natural Gas Orifice Spud Chart for High Altitude Conversion
See the chart in the Natural Gas High Altitude Conversion
Instructions.
Burner Locations
15" (38.1 cm) Models
A
B
A
A. Center burner A. Rear burner
B. Front burner
5. Remove all burner caps and burner bases. Be sure to keep
the cap and base for each burner together. This will assure
that the cap and base are reinstalled on the proper burner.
A
B
C
Single Burner
A. Cap
B. Spreader
C. Electrode
Double Burner
A. Cap
B. Spreader
C. Electrode
6. To convert burners:
■ Insert 7.0 mm nut driver down onto the gas orifice
spud (C) and remove by turning it counterclockwise
and lifting out.
■ Set gas orifice spud aside.
■ Replace with correct Natural gas orifice spud. See the
Natural Gas Orifice Spud Chart.
A
B
C
A
C
B
D
Standard Burner
A. Igniter electrode
B. Orifice holder
C. Orifice spud
Double Burner
A. Igniter electrode
B. Orifice holder
C. Orifice spud
D. Orifice simmer
IMPORTANT: Place Propane gas orifice spuds in plastic
parts bag for future use and keep with package containing
literature.
7. Replace burner bases and burner caps.
IMPORTANT: Be sure that the electrode aligns with the
notch or hole in the burner base. The igniter electrode is
ceramic and could break during installation of the burner
base.
A
B
C
D
Dual Flame Burner
A. Inner cap
B. Outer cap
C. Spreader
D. Electrode
A
C
B
Dual Flame Burner
A. Igniter electrode
B. Orifice holder
C. Orifice spud
B
C
A
A. Burner cap
B. Electrode
C. Burner base