Installation Guide
24
Natural Gas Conversion
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation 
instructions.
Slide range back so rear range foot is engaged in the 
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed 
and engaged.
Failure to follow these instructions can result in death 
or serious burns to children and adults.
1.  Turn manual shut-off valve to the closed position.
A
B
A. To range
B. Shut-off valve (closed position)
C. Gas supply line
2.  Unplug range or disconnect power.
6.  Unscrew the metal cover and unscrew the blue regulator 
cap. Keep the washer in place.
A
B
A
C
A. Metal cover
B. Washer
C. Blue regulator cap
7.  Flip the blue regulator cap over and screw it back into 
the metal cover.
A. Propane gas position
B. Natural gas position
A
B
8.  Screw the metal cover securely back into place. 
Do not overtighten.
  IMPORTANT:  Do not remove the gas pressure regulator.
3.  Remove the front lower panel of the range.
4.  Disconnect the blower motor electrical connections.
5.  Disconnect the downdraft blower bellows from the range.
A
A. Gas pressure regulator
IMPORTANT: Make sure to save the orifices that have 
just been replaced in the conversion.
Complete Installation (Natural Gas to Propane Gas)
1.  Refer to the “Make Gas Connection” section for proper 
connection of the range to the gas supply.
2.  Refer to the “Electronic Ignition System” section for proper 
burner ignition and operation.
3.  Refer to the “Adjust Flame Height” section for burner ame 
adjustments.
   IMPORTANT:  You may have to adjust the low setting for 
each cooktop burner.
   Checking for proper cooktop burner ame is very important. 
Natural gas ames do not have yellow tips.
4.  Refer to “Complete Installation” in the “Installation 
Instructions” section of this manual to complete this 
procedure.
To Convert Gas Pressure Regulator  
(Propane Gas to Natural Gas)
1.  Move the range out from the wall.
2.  Locate the gas pressure regulator at the lower right corner 
on the back of the range.










