Installation Instruction

ManualsBrandsJennAir ManualsAppliancesJennAir - NOIR™ 36" Dual-Fuel Professional-Style Range with Chrome-Infused Griddle and Steam Assist - Floating Glass Black

Adjusting Simmer Low and Main Setting on Surface

Burner for Natural Gas

1. Remove the surface burner control knobs and bezels (oven

control knobs and griddle control knobs do not have to be

removed).

2. Locate the Simmer low-turndown adjustment screw through

the bezel on the left side of the ignition switch.

3. With the burner ON, and set to Simmer Lo, adjust the

simmer ame down to the proper BTU level. Using a

1/8" x 4

" (3.2 mm x 10.8 cm) at blade screwdriver,

turn the simmer low-turndown adjustment screw

counterclockwise until the ame becomes stable, does not

icker, or appear to race around the burner. Once the ame

is stable, turn the burner rate to SIMMER HIGH setting. The

ame should increase to approximately 2X the ame height.

If not, the low-turndown may be able to be adjusted low and

still remain stable. Repeat this step for all surface burners,

except the grill burner.

NOTE: Use a knob to adjust the burner valve.

NOTE: If your range has the IR grill, then skip ahead to the

Convert IR Grill Burner section.

NOTE: Adjust each burner individually.

4. With burner OFF, using the same at blade screwdriver, turn

the main low-turndown adjustment screw 120-135 degrees

counterclockwise. This will set the main low burner rate to a

proper level.

5. Replace the bezels using the 2 screws which attach to the

valve brackets.

6. Push the surface knobs onto the valve stems.

7. Replace burner grates.

To Convert IR Grill Burner for Natural Gas

1. Unplug range or disconnect power.

2. Remove grill knob and bezel. The other surface knobs and

bezels should still be off the range.

3. Open the oven door and remove the two screws on each

side of the range that hold the control console in place.

NOTE: Make sure to leave oven door open or the control

console will not rest in the side brackets properly once it is

detached.

4. Pull up on the control console and let it drop forward into the

notched console brackets on each side.

5. Remove the two screws holding the grill orice holder

bracket.

6. Pull the grill orice holder out of the burner box far enough

away to allow access to the orice with a wrench, using

caution not to kink the attached tubing.

A B C

A. Simmer low-turndown adjustment screw

B. Ignition switch

C. Main low-turndown adjustment screw (inside stem)

A. Control console bracket

A. Screws

B. Grill orice holder bracket

A. Grill orice

B. Grill orice holder