Manual

Thisrangehoodcanbesetforrearventingusingthe31¼"x 10"
(8.3x25.4cm)rectangulardamper(supplied).
1. Using2ormorepeople,setrangehoodontoitsbackona
coveredsurface.
2. Pushinthebottomofthecenterglasstounlatch,andliftto
open.Removethe2screwsthatholdittothecanopy.Setthe
glasscoverandthemountingscrewsaside.
6. Removethe4screwsholdingtheblowermotortothecanopy
top.Pushbloweruptoreleasethemountingtabsfromthe
keyholeslots.Removeblowermotor.Setblowermotorand
mountingscrewsaside.
0
B
o
A
3,
4.
A. Remove these screws.
Remove metal filter. See the "Range Hood Care" section.
Disconnect the blower wiring plug.
A
A. Keyhole slot
B. Mounting tab
7. Remove the 4 screws from the cover plate on the back of the
canopy.
8. Install cover plate over the rectangular top exhaust hole using
its 4 mounting screws. Tighten screws.
B ..........................................!l®® ® I
5,
A. Blower wiring plug
B. Blower
Remove the 4 mounting screws holding the 8" (20.3 cm)
diameter transition damper to the canopy top. Set the
damper and mounting screws aside.
A
A. Remove cover plate from here.
B. Replace cover plate here.
A. Damper mounting screws
8