Manual

Thisrangehoodisfactorysetfor8"(20.3cm)roundventing

throughtherooforwall.An8"(20.3cm)roundventsystemis

neededforinstallation(notincluded).Toventthroughthewall,a

90°elbowisneeded.

Thisrangehoodcanalsobesetforrearventingusingthe

3_¼"x 10"(8.3x25.4cm)rectangulardamper(supplied).Seethe

"ConnectVentSystem- ForRearVentingInstallationOnly"

section.

For vented installations only:

For non-vented (recirculating) installation without vent

cover only.

1. Push in the bottom of the center glass to unlatch, and lift to

open.

2. Remove metal filter. See the "Range Hood Care" section.

3. Remove the 4 mounting screws holding the 8" (20.3 cm)

diameter transition damper to the canopy top. Set the

damper and mounting screws aside.

1. Fit vent system over transition piece.

2. Seal connection with clamps.

3. Check that backdraft dampers work properly.

For non-vented (recirculating) installation with vent

cover only:

1. Assemble the air deflector with the duct cover bracket with

4 - assembly screws provided with the Recirculation Kit.

A. Assembly screws

B. Air deflector

C. Duct cover bracket

Measure from the bottom of the air deflector to the bottom of

the hood exhaust outlet.

A. Damper mounting screws

4. Install the top grille cap using the mounting screws included

in the Recirculation Kit.

D............................. x_C

E .............'--._7

A. Air deflector

B. Vent clamp

C.X = length to cut vent duct

D. 8" (20.3 cm) dia. round vent duct

E. Hood exhaustoutlet

3. Cut the duct to the measured size (X).

4. Remove the air deflector.

5. Slide the duct onto the bottom of the air deflector.

6. Place the assembled air deflector and duct over the exhaust

outlet from the hood.

7. Reassemble the air deflector to the duct cover bracket with

4 assembly screws.

8. Seal connections with vent clamps.