Installation Instructions

6
INSTALLATION INSTRUCTIONS
Install Oven
(24" [59.5 cm] Installation Only)
NOTE: For this oven, the door handle may be used for lifting.
Do not use any other portion of the control panel, side brackets,
front frame or trim for lifting.
1. Empty oven of any loose items.
2. Using two TKX 4x12 PZ2
®
screws, attach the bottom trim to
the cabinet.
3. Using 2 or more people, slide the oven all the way into the
opening.
4. Center the oven within the opening. Open the oven door.
5. Mark 4 holes (2 on each side) in the door facing frame of the
oven.
6. To avoid damage to the frame while drilling during the next
step, close the door and remove the oven.
7. Drill the 4 holes using 5/64" (2 mm) drill.
8. With the oven near the opening, plug the oven into the
grounded 3-prong outlet.
9. Replace oven in cutout opening
10. Open the oven door. The holes in the door facing frame
should align with the holes just drilled into the cabinet.
Fasten the oven door facing to the cabinet using four
4x25 PZ2
®
screws.
11. Proceed to “Complete Installation” section.
Complete Installation
1. Check the steam oven by running the steam and convection
bake functions according to the Use and Care Guide.
2. If the steam oven does not operate:
■ Check that a household fuse has not blown, or a circuit
breaker tripped. Replace the fuse or reset the circuit
breaker. If the problem continues, call an electrician.
■ Check that the power supply cord is plugged into a
grounded 3 prong outlet.
■ See the Use and Care Guide for troubleshooting
information.
Installation is now complete.
Save these Installation Instructions for future use.
If you need Assistance or Service:
Please reference the “Assistance or Service” section of the
Use and Care Guide, or contact the dealer from whom you
purchased your built-in oven.
WARNING
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
A
B
C
A. Door facing frame
B. Trim panel
C. 4x25 PZ2
®
screws (4)
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING