Installation Instructions

2
INSTALLATION REQUIREMENTS
Tools and Parts
Tools needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
■ Measuring tape
■ Pencil
■ PZ2
®
Pozidriv
®✝
screwdriver
■ Electric drill
■ 5/64" (2 mm) drill bit
Parts Supplied
■ TKX 4x12 PZ2
®
screws (2 for bottom trim)
■ Bottom trim
■ 4x25 PZ2
®
screws (4 for oven installation)
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
■ Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance with oven.
■ Recessed installation area must provide complete enclosure
around the recessed portion of the oven.
■ Grounded electrical supply is required. See “Electrical
Requirements” section.
■ Oven support surface must be solid, level and ush with
bottom of cabinet cutout. Floor must be able to support an
oven weight of 111 lbs (50 kg).
IMPORTANT: To avoid damage to your cabinets, check
with your builder or cabinet supplier to make sure that the
materials used will not discolor, delaminate or sustain other
damage. This oven has been designed in accordance with
the requirements of UL and CSA International and complies
with the maximum allowable wood cabinet temperature of
194°F (90°C).
Undercounter Installation (with cooktop installed above):
Ovens approved for this type of installation have an approval
label located on the top of the oven. Refer to undercounter
installation instructions for cutout dimensions and approved
oven cooktop combinations (separate sheet).
Product Dimensions
Top View
A. 23
7
/
16
" (59.5 cm)
B. 18
5
/
16
" (46.5 cm)
C. 14" (35.6 cm)
D. 13
1
/
8
" (33.3 cm)
E. 13/16" (2 cm)
F. 3/8" (1 cm)
G. 20
3
/
8
" (56.9 cm)
H. 21
15
/
16
" (55.7 cm)
E
F
BC
D
A
G
H
I
20³/₈"
(51.7 cm)
19⁵/₈"
(49.7 cm)
26¹/₄"
(51.7 cm)
33"
(83.8 cm)
AB
CD
A. Oven
B. Non-ush receptacle
C. Flush receptacle
D. Non-ush receptacle located in
upper right or upper left corner
E. Oven door fully open
✝PZ2 and POZIDRIV are registered trademarks of Phillips Screw Company.