Owner's Manual

13
2. Remove the foot from the right front spacer by removing the
#8-18 x 3/8" screw.
NOTE: Do not remove the spacer.
A. Spacer
B. Foot
C. #8-18 x 3/8" (9.5 mm) screw
3. In the same manner, remove the feet on the right rear, left
front, and left rear of the oven.
4. Using 2 or more people, place the oven in its upright position.
5. Go to the “Make Electrical Connection” section.
Cutout Height is Between 28
11
/
16
" and 29
7
/
16
" (72.8 cm and
74.8 cm)
NOTE: For installation, the long shield is required to replace the
shield that came with the unit. Please refer to your serial tag for
the service number to call and request at no charge.
1. Using 2 or more people, place the oven on its back on a
covered surface.
2. Remove the foot from the right front spacer by removing the
#8-18 x 3/8" (9.5 mm) screw.
NOTE: Do not remove the spacer.
A. Spacer
B. Foot
C. #8-18 x 3/8" (9.5 mm) screw
3. Rotate the foot 90° so the short side of the foot is positioned
toward the top of the oven.
4. Reinstall the foot to the spacer using the #8-18 x 3/8"
(9.5 mm) screw previously removed.
5. In the same manner, remove, rotate and reinstall the feet on
the right rear, left front, and left rear of the oven.
6. Using 2 or more people, place the oven in its upright position.
7. Go to the “Make Electrical Connection” section.