Tech Sheet

FOR SERVICE TECHNICIAN’S USE ONLY
8
DISPLAYED MESSAGE POSSIBLE CAUSE SOLUTION
SELECT A MILDER TASTE OR
REDUCE PRE-GROUND COFFEE
QUANTITY
Too much coffee has been used.
Select a milder taste by pressing or reduce the quantity
of pre-ground coffee (maximum one measure).
GROUND TOO FINE.
ADJUST GRIND LEVEL 1
CLICK WHILE IN OPERATION
The grinding is too ne and the coffee is delivered too
slowly or not at all.
Repeat coffee delivery and turn the grinding adjustment dial
one click clockwise towards number seven while the coffee
mill is in operation. If after making at least two coffees
delivery is still too slow, repeat the correction procedure,
turning the grinding adjustment dial another click. If the
problem persists, make sure the water tank is fully inserted.
If the water lter is present, an air bubble may have been
released inside the circuit, obstructing delivery.
Insert the hot water/steam spout in the appliance and
deliver a little fresh water until the ow becomes regular.
INSERT BREWING
UNIT
After cleaning, the infuser has not been replaced. Insert the infuser.
INSERT MILK CONTAINER The milk container is not inserted correctly. Insert the milk container as far as it will go.
INSERT GROUND CONTAINER
AND DRIP TRAY
After cleaning, the grounds container has not been
replaced.
Remove the drip tray and insert the grounds container.
INSERT WATER OUTLET The hot water spout is not inserted or is inserted
incorrectly.
Insert the water spout as far as it will go.
WATER CIRCUIT EMPTY PRESS
OK TO START FILLING PROCESS
The water circuit is empty.
Press
OK
and allow fresh water to drain out of the spout;
the ow will stop itself automatically. If the problem persists,
make sure the water tank is fully inserted.
PRESS OK TO START CLEANING
PROCESS OR TURN MILK
FROTH ADJUSTMENT KNOB
The milk container has been inserted with the froth
adjustment dial in the CLEAN position.
To proceed with the CLEAN function, press
OK
or turn
the froth adjustment dial to one of the milk positions.
ESC