Tech Sheet

7
Troubleshooting
DISPLAYED MESSAGE POSSIBLE CAUSE SOLUTION
ADD PRE-GROUND COFFEE,
PRE-GROUND MAXIMUM ONE
MEASURING CUP
The “Pre-ground coffee” function has been selected, but
without placing any pre-ground coffee in the funnel.
Place pre-ground coffee in the funnel and repeat delivery.
The funnel for pre-ground coffee is clogged. Empty the funnel using the brush provided.
A “Tall” coffee with pre-ground coffee has been requested.
Place pre-ground coffee in the funnel and press
OK
to
continue and complete delivery.
EMPTY GROUND CONTAINER The grounds container is full. Empty the grounds container and drip tray, clean and
replace them.
IMPORTANT: When removing the drip tray, the grounds
container must always be emptied, even if it contains
a few grounds. If this is not done, when you make the
next coffees, the grounds container may ll up more than
expected and clog the machine.
DESCALING NEEDED, PRESS OK
TO START (~45 MIN)
Indicates that descaling is needed.
Press
OK
to start descaling or press
ESC
to descale
later. The descaling procedure described in the “Descaling”
section needs to be performed.
FILL BEAN CONTAINER The coffee beans have run out. Fill the beans container.
FILL WATER TANK WITH FRESH
WATER
The water tank is empty or incorrectly positioned. Fill the tank with fresh water and or insert it correctly
pushing it as far as it will go until it clicks into place.
GENERAL ALARM: REFER TO
USER MANUAL
The inside of the coffee system is very dirty. Clean the inside of the appliance thoroughly. If the message
is still displayed after cleaning, contact an authorized
Customer Service Center.
ESC
OK