Installation guide

m_ Use the Standard Grille brackets for a Standard
Installation with a flush grille, as shown. Install Door Panels
NOTE: French door models, first open the door opposite from the
one to which you are installing the door panel.
1. Lower the panel bracket onto the door adjustment pins at the
top of the door.
A. Top grille brackets
B. Grille trim piece
| ; ; . A. Door panel C. Adjustment pins
2. Using round head screws (provided with refrigerator), attach B. Panel top bracket
the grille trim piece to the bottom of the grill panel.
NOTE: The grille trim is preinstalled on the panel kits. 2. Locate the studs on the back of the door panel. Slide the
studs, top stud first followed by the bottom stud, into the “J”
pockets in the front of the door.
NOTE: It is the washer in the stud, not the head of the stud,
that is inserted in the “J” pocket.
Remove Trim Pieces
1. Remove all tape and door bracing from the refrigerator and
freezer doors. 3. Slide the door panel down into the “J” pocket.
2. Open the refrigerator and freezer doors. 4. French door models, repeat steps 1 through 3 to install the
3. Remove the hinge cover trim pieces from the top and bottom second door panel.
NOTES:
m_ ltis not necessary to remove the hinge side trims as they
will not interfere with the installation
m_ Leave the freezer drawer trims in place for installation.
4. Remove the handle side trims. See the following graphic.
of the door to expose the holes in the hinges. =
——
A
Cd) ls
Ll
oO U
5. Using a slotted hex head screw (provided with refrigerator),
attach the mounting bracket (factory installed), located at the
bottom of the refrigerator door(s), to the respective door
panel(s). Do not fully tighten the screw.
Fo ye
é
A B
A. Hinge cover pieces
B. Handle-side door trim A. Bottom hinge
B. Mounting bracket
24