Instructions / Assembly

2Adjustable Sill Pan
ADJUSTABLE SILL PAN INSTALLATION INSTRUCTIONS
CONTENTS
Door sill pan contains 3 parts:
A, C Door sill pan left and right end caps (2)
B Door sill pan (1)
NOTE
Check rough opening to determine if the installation
will be on a step down or flush to the floor.
See examples of each below.
A CB
STEP DOWN
If the installation is on
a step down from the
floor, the sill pan and
end caps are ready to
use as packaged.
FLUSH TO THE FLOOR
If the installation is
flush to the floor, the
sill pan and end cap
overhang lips need to
be trimmed off.
2
Place the left and right sill pan end caps tightly in each
corner of the rough opening and measure the distance
between to determine the cut length for the sill pan. Cut the
sill pan to the measured length. Before moving to next step,
remove both end caps.
Measure and Cut to Fit
1
NOTE: THE SILL PAN MUST BE INSTALLED ON A LEVEL SURFACE.
If the installation is on a step down, proceed to step 2. If the
installation is flush to the floor, trim off the overhanging lips
from the sill pan and left and right end caps. Proceed to step 2.
Trim Here
BEFORE AFTER
5
Firmly press the sill pan into the silicone.
Product images are for illustration purposes only. Actual product may vary slightly in style, color, pattern or finish.
www.simplyelegantproducts.com/sillpan
3
Apply four 3/8” beads of silicone along the entire length of the
rough opening AND continue 2” up each side of the opening.
For installation on a step down, also apply one 3/8” bead of
silicone to the outer edge of the step down.
Also, 2” up
each side
Press the left and right end caps firmly into the sealant.
Nail each end cap to the rough opening using the nail slot
provided. Remove the adhesive tape protective cover from
each end cap.
4
Nail slot for securing end
cap to rough opening
Outside
Sill Glazing Tape
Outside
6
Apply one 3/8” bead of sealant in the
1
left and
2
right
corners where the sill pan fits against the end caps. For
flush to the floor installation only,
3
also apply one 3/8”
bead of silicone to where the front outer edge of the sill pan
meets the floor. Use an applicator to smooth out beads of
silicone (see diagram at left). Now install door unit (follow
manufacturer’s installation instructions).
Flush to
floor only!
1
2
3
SMOOTHING OUT THE SILICONE
In step 6, use
an applicator to
smooth out the
silicone.