How to Guide

Service Supplement
for Barn Door Bar Application (SVC-90004)
2
SELECT DESIGN
2-PANEL DESIGN BAR APPLICATION INSTRUCTIONS
1"
1
"
6"
37 3/4"
46 11/16"
1. Prepare surface by using a dry, clean cloth to remove all loose dust and
debris from the bars and panel.
2. Designate top and bottom of the door.
Note: 1-Panel door is identical top and bottom.
3. Dry t Horizontal bar.
a. Measure 37 3/4" (46 11/16" for the 6-lite) from top of door to
top edge of the bar. Carefully mark this position for both ends of
the bar.
4. Apply wood glue to back of bar.
a. Glue Pattern: Apply 3 lines the full length of the bar with 1/4"
bead size.
5. Place bar glue side down and fasten bar to door with nish nails.
a. (2) #18 x 3/4" nish nails approximately every 6 inches.
6. Wipe any excess glue that may have squeezed out.
7. Turn door over and repeat from step #1 for the back side of the door.
8. Proceed to JII-90003 (Contained in hardware box) for instructions on
installing DesignGlide Hardware.
9. See our nishing instructions on jeld-wen.com.
K-Design
K-Design
2-Panel Design
2-Panel Design
1-Panel Design
1-Panel Design