Installation Guide

JELD-WEN DesignGlide Barn Door Hardware System Installation

(JII-90003)

STEP 4: TRACK INSTALLATION

Install soft close to track.

1. Align the soft closes ⑰ on the track as shown in Figure 16, with

catches cocked towards the center of the track.

2. Fasten the soft close to the track using the supplied M4 x 35mm

socket cap screws ⑱, M6 washers ⑲ and M4 locking nuts ⑳.

3. Fasten with supplied 3mm Allen wrench ⑨.

Orient both soft close mechanisms with

movable catches toward center of track

Figure 16. Soft Close Orientation

Fastening track to backer board.

1. Secure the rst and last holes in the track ① using a 55mm lag bolt

③, M8 washer ⑤, passive end stop ④ and standoff ⑥.

2. Secure the rest of the holes with a 55mm lag bolt ③, M8 washer ⑤

and standoff ⑥.

Figure 17. Track Assembly

STEP 5: FLOOR GUIDE INSTALLATION

1. Reference Figure 14 on Page 7, to locate the installation location of

the oor guide, relative to open/closed positions of the system.

2. Using a pencil, mark 2" away from the wall and 1.5" in from the

interior edge of the opening.

Note: If there is a baseboard, take its thickness into consideration.

3. Predrill with a 3/32" bit, 1" deep. If installing into a concrete oor,

predrill with a 1/4" bit, 1 3/8" deep.

4. Assemble oor guide as shown in Figure 18. If installing into

concrete, install oor ⑯ anchor into predrilled hole.

5. Hand tighten the oor guide in place, ensuring the rubber base has

the ability to rotate.

Figure 18. Floor Guide Assembly

⑱

⑰

⑳

⑲

⑨

③

⑤

⑥

③

④

⑤

⑥

①

⑯

⑮

1 1/2"