Installation Guide

A
B
22 OR 24
11
JELD-WEN DesignGlide Barn Door Hardware System Installation
(JII-90003)
STEP 8: INSTALL AND ADJUST SOFT CLOSE
Attach soft close triggers.
1. Tighten anti-jump rods into the soft close trigger assemblies ⑧ using
supplied 3mm Allen wrench ⑨.
2. Slide door to center of track.
3. Slide triggers onto rail using the measurements/formulas in Table 5 as
guidelines.
a. Measurement 'A' is taken from edge closest to handle, as shown in
Figure 24.
b. Measurement 'B' is taken from the opposite edge of 'A'.
4. Secure triggers ⑧ in place with set screws using supplied 3mm Allen
wrench ⑨.
Anti-Jump Rod
Figure 23. Soft Close Trigger Installation
Kit Size Door Width (DW) A B
36" (72" Track)
30" ≤ DW < 32 1/2" = (2*Door Width) − 54 1/2" 1/2"
36" ≥ DW ≥ 32 1/2" 10 1/2" = Door Width – 28 1/2"
42" (84" Track)
36" < DW < 38 1/2" = (2*Door Width) – 66 1/2" 1/2"
42" ≥ DW ≥ 38 1/2" 10 1/2" = Door Width – 34 1/2"
Figure 24. Soft Close Trigger Alignment
Table 5. Soft Close Locations
STEP 9: INSTALL TOP END CAPS
Use (2) #10 x 1" pan head screws ⑪, secure both end caps ⑩ in place.
Pan Head, #10 x 1"
Figure 25. End Cap Installation
⑧
⑨
⑧
⑪
⑪
⑩