Instructions / Assembly

Installation Instructions
for Genius
®
ZigZag1 Retractable Screen System (JII-90043)
4
Begin by locating the Side Guides (B on page 2). Install one on each side of the opening and push to the top. Secure using #8 x 3/4" Phillips Screws in
the pre-drilled holes on each side (1A below). Next, install the Top Guide (A on page 2) by tucking each end into the Side Guides and centering it in the
opening. Secure with # 8 x 3/4" Phillips Screws in the pre-drilled holes (1B below).
Clean the bottom mounting surface and ensure it is solid, at, and level. If needed, create a at, smooth, and level surface. Locate the Bottom Guide and
position it so it is centered in the opening and tucked into the Side Guides. The white paper backing should be facing down. (NOTE: The adhesive is very
sticky. Use care when positioning). Remove the paper backing from the Bottom Guide and adhere it to the bottom sill.
1A 1B
INSTALL SIDES AND TOP GUIDES
1
INSTALL BOTTOM GUIDE
2