Installation Guide

7
Installation Instructions
for Wood Patio Doors without Exterior Trim or Nail Fin (JII027)
COMPLETE INSTALLATION
6
1. On the exterior, apply backer rod and sealant between the frame
head/side jambs and the roughopening.
2. Ensure sealant on back dam of the sill pan fully seals to the inside
face of the sill. Apply more sealant as necessary.
3. Install lockset hardware per manufacturer’s instructions.
4. Some French double door units may require installing lock bolts at the
top and bottom of the inactive panel. Locate the center point of each
lock bolt, drill 3/8" bolt holes and install keeper plates.
Please refer to our product guide: JPG012 on jeld-wen.com for lock
and roller adjustments.
Adjust Lock
1. Loosen the lock hook
screws in the side jamb
so it can be moved up
ordown.
2. Insert the alignment
guide into one of
the openings in
thefaceplate.
3. Carefully close the panel
and raise or lower the
lock hook until it aligns
with the slots in the
faceplate. Tighten the
screws.
4. To lock the door, rotate
the thumb turn 90°.
Adjust Sliding Door Panel Rollers
NOTE: Adjust the panel high enough to avoid drag. Keep door
panel parallel to the jamb by almost closing the door and looking
for an even reveal/gap.
NOTE: Lift up the panel or use a small pry bar to lift the panel to
take the weight off the rollers before adjusting the rollers.
Remove both door roller adjustment plugs on the interior bottom of
the operating panel. Using a phillips head screwdriver, turn the screw
counterclockwise to raise the panel or clockwise to lower it.
Install Exterior Trim
For wood exterior doors
not assembled with exterior
casing, attach the pre-cut
exterior from the interior
frame edge to the sides and
head with 2-1/2" casing
nails. Seal exterior to frame
with sealant and tool into a
lletjoint.
Backer rod
and sealant
Lock
hook
Faceplate
Alignment
guide
Frame
Panel
Exterior trim
9/16"
gap