Installation Guide

ManualsBrandsJELD-WEN ManualsExterior Doors72-in x 80-in Blinds Between The Glass Brilliant White Clad-Wood Left-Hand Sliding Double Door Sliding Patio Door

Installation Instructions

for Wood Patio Doors without Exterior Trim or Nail Fin (JII027)

Apply Drip Cap (if supplied)

1. With the exterior face

up, apply a 1/4" bead

of sealant across the

header asshown.

2. Center the drip cap

on the header and

mechanically fasten

with appropriately

sized nails or screws.

Be sure the fastener

does not completely

penetrate the

frameheader.

PREPARE PATIO DOOR

INSTALL PATIO DOOR

3. Inswing/outswing

doors will need a

strip of self-adhered

ashing applied

over the dead bolt

or latch hole on the

exterior side of the

frame asshown.

Sealant

Deadbolt

hole

WARNING! To avoid injury, use at least two people to install.

Adequately support the door until fully installed.

Shim the Jambs

NOTE: Each location must be shimmed with two opposing shims

(if tapered). Secure all shims with sealant.

1. From the interior,

shim the hinged

side jamb at every

hinge (swinging

doors). Shim the

latch jamb 6" from

the corners and at

the strikeplate.

2. Shim all other

jambs 6" from

the corners and at

center.

3. Shim the head

jamb 6" from the

corners of each

panel and at the

strike plate if present. Position shims so that strike plate screws will

penetrate shims.

4. Inspect the patio door for square, level and plumb. Test for proper

operation (remove and reinstall if necessary).

5. For center hinge patio doors only, check for proper reveal (clearance)

between the frame and panels at the side jambs and head as shown.

Secure Patio Door

NOTE: Apply sealant to screw threads before installing. Countersink

for wood putty or plug covers if desired. On the Custom Wood

Inswing door the screws will have to be driven through the exterior

door jamb on the stationary side.

1. Fasten patio door

using #8 x 2-1/2"

screws through the

shims in the jambs

and next to the

shims in the head:

2" from the corners

and 16" oncenter.

2. Secure each strike

plate through the

shims with screws

provided.

STEPS 3 and 4 are for

swinging doors only

3. Unlock the deadbolt

with a small athead

screwdriver and

opendoors.

4. Remove any shipping

blocks.

Strike

plate

3/32"

1/4"

Deadbolt

unlocked

Deadbolt

locked

1/8"

16"