How to Guide

Sliding/Gliding Roller Adjustment and Replacement
Note! Adjusting door too high may allow water and air leakage.
Adjusting rollers too low can cause panel to drag on lower track.
Adjust rollers just high enough to clear sill track and keep the
weatherstrip hidden when the door is closed. You may need to
raise one roller and lower the other. Check by almost closing the
door and looking for an even, parallel gap.
1. Adjustment holes
are located at both
lower ends on the
face of the panel,
or on the end of the
operating panel(s).
Remove small plastic
plugs from each
hole (ifpresent).
2. Open operating
panel enough
to compare with
framejamb.
3. Lift the panel to
take the weight off
of the roller and
turn the adjustment
screw in 1/4 turn
increments with a
screwdriver (do not
use a power driver).
Some panels with
face adjustment
holes will have a
(+) or a (-) sign in
the adjustment
hole. If a sign is
not present, or it is a (+), clockwise rotations will lower the panel, and
counterclockwise rotations will raise the panel. Opposite adjustments
apply to the (-) sign. Use a Phillips screwdriver for end adjusted rollers.
Clockwise rotations will raise the panel, and counterclockwise rotations
will lower the panel.
4. Adjust as needed until interlocks, grid patterns, and jambs line up.
5. Test the operating panel for proper operation.
6. Re-apply the small plastic caps over the roller adjustment screw holes if
applicable.
Roller Assembly Replacement
1. Remove operating panel and lay on at surface.
2. At the bottom of the panel, remove both Phillips screws from
rollerassembly.
3. Remove roller assembly.
4. Install new roller assembly in the same place.
Lock Replacement and Adjustment
Locking mechanisms have changed over time and can be very
complex. The following instructions provide basic lock servicing
procedures, but cannot fully explain every possible situation. For
help with identifying your lock type and for specic instructions
not found here, please contact us.
Single-Point Sliding Door Handle and Lock Replacement
Compare replacement
handle set or lock to
your existing hardware
to make sure you
have the correct
newhardware.
When removing screws
and parts, keep track
of their exact locations
forreinstallation.
1. Remove screws from
the interior handle.
2. Remove handles
(interior and
exterior), the interior
lock lever and the exterior keyway lock.
3. Remove the attachment screws from the lock assembly in the
dooredge.
4. Remove the lock assembly.
5. To install, reverse these instructions.
Single-Point Sliding Door Lock Adjustment
Make horizontal adjustment as follows:
1. Open panel and
locate the lock
assembly.
2. Use a small
screwdriver to turn
the adjustment
screw located on
the face of the lock.
3. Turn the screw
counterclockwise to
reduce the length of
the latch hook. Turn
screw clockwise
to lengthen the
latchhook.
4. If necessary, shims can be ordered and placed behind the strike plate.
Please contact us.
Make vertical adjustments as follows:
1. Loosen the keeper screws.
2. Adjust keeper up or down to align with lock strike and retightenscrews.
Face Adjusted Roller
End Adjusted Roller
Single-Point Sliding Door Lock Replacement
Single-Point Sliding Door Lock Adjustment
Adjustment
screw
Attachment
screws
Lock
hook
Handle
lever
Interior
handle
Strike
plate
Lock hook
adjustment
screw
Product Guide
Wood Patio Doors (JPG012)
05/19
8
HARDWARE REPLACEMENT AND ADJUSTMENT - CONTINUED