How to Guide

These instructions are for the removal and installation of the Truth patio
door screen roller utilized on the JELD-WEN 1350 or 1580 aluminum series
screen door.
Screen Roller Removal
Remove the screen before
starting roller replacement.
1. Locate the wheel inside
the wheel pocket.
2. Grab the wheel between
your thumb and index
nger and rotate the
wheel assembly upwards
(perpendicular to the
door frame).
a. Note: Due to the
tension of the spring
inside of the frame, a
small amount of force
will be required.
3. Once rotated upwards,
simply lift the roller out
of the wheelpocket.
Because panel removal can be awkward and could cause physical
injury or product damage, we recommend the help of additional
people. Removing the operating panel may be easier if the rollers
are rst retracted, lowering the panel.
Operating Panel Removal- For Professionals Only
Custom, EpicVue
™
and Pozzi Doors
1. Close and lock the operating panel.
2. Gently remove
interior head trim
with small prying
tool being careful
not to damage
thewood.
Note! Do not remove
nails from trim if,
present, unless
necessary. This
makes replacement
easier.
3. Remove the operating panel by sliding it away from the side jamb. Tilt
the top of the panel to the interior, remove head track and lift up and
over the sill track.
Norco, Caradco French View/French Manor, Siteline and
W-2500Sliding Patio Doors
1. Remove bumper(s). Some doors have a bumper in the stationary panel
side jamb and some will have one in the head and sill. This will allow
the operating
panel to open wide
enough to gain
access to the screws
in the head track.
2. Unlock and open
door all the way and
remove the exposed
screws from the
head track with a
Phillips screwdriver.
3. Close and lock
operating panel
to prevent it from
falling out of the
frame opening.
4. Remove screws from
opposite side of the
head track.
5. Unlock operating
panel and carefully
slide open. For
Siteline doors,
lower the panel by
adjusting the rollers
up into the panel.
The head track can
now be pulled out from above the operating panel.
Screen Roller Installation
1. Insert spring into pocket
of frame, opposite of
corner key.
2. Rotate the roller upwards
so that the body of the
assembly is perpendicular
to the door frame.
a. Note: Due to the
tension of the spring
inside of the frame, a
small amount of force
will be required.
3. Push the roller assembly
onto the corner key,
aligning the pivot tabs of
the roller into the pivot
pockets of the key.
4. With roller positioned
into corner pivot pockets,
rotate away from the
corner key and push
the roller down into
theframe.
Wheel
Spring
Interior
head trim
Bumper(s)
Head
stop
Head track
Screw
Operating
panel
Score
W-2500 Sliding Patio Doors
Product Guide
Wood Patio Doors (JPG012)
05/19
3
SCREEN REMOVAL & INSTALLATION
|
SCREEN ROLLER REMOVAL & REPLACEMENT - CONTINUED
SLIDING/GLIDING PATIO DOOR PANEL REMOVAL AND INSTALLATION