Manualshelf

Installation Guide

ManualsBrandsJELD-WEN ManualsPatio DoorsClear Glass Brilliant White Clad-wood Right-hand Double Door Sliding Patio Door (Common: 72-in x 80-in; Actual: 71.25-in x 79.5-in)
12345678
4
Installation Instructions
for Wood Patio Doors without Exterior Trim or Nail Fin (JII027)
• Verify the width and height of the patio door are each 1/2"-3/4"
smaller than the rough opening width/height. Mulled units should be
3/4"smaller.
Remove Packaging
Remove shipping materials such as corner covers, shipping blocks or pads.
Remove the skid board attached to the bottom of the door. Remove any
staples exposed on the frame, but leave any glass protective lms on.
Inspect Patio Door
• Cosmetic damage.
• Correct product (size, color, grid pattern, handing, glazing, energy-
efciency requirements, etc.).
If any of the above conditions represent a concern, or if you expect
environmental conditions to exceed the patio door’s performance rating,
do not install the patio door. Contact your dealer or distributor for
recommendations.
• Verify the rough opening is square. The (A) and (B) measurements
should be the same. Maximum allowable deviation from square is
1/8" for doors less than 20 square feet and 1/4" for doors over 20
squarefeet.
• Verify the rough opening is plumb and level (C, E and D). The maximum
allowable deviation is 1/8".
• The rough opening sill must not be crowned or sagged (D), but rather
level or sloped (positive slope) to the exterior.
• The exterior face of the rough opening must be in a single plane (E)
with less than 1/8" twist from corner to corner.
• Minimum double studs should be used at all wood framed
roughopenings.
• The header must be supported by trimmer studs.
For Retrot Installations
After removing the old patio door, remove sufcient cladding (siding,
stucco, etc.) to expose enough intact building wrap to properly seal the
patio door to the opening. If damaged, apply new building wrap in shiplap
manner. Verify the rough opening framing is structurally sound. Contact
your local waste management entities for proper disposal or recycling of
products being removed.
REMOVE PACKAGING AND INSPECT PATIO DOOR
INSPECT ROUGH OPENING
1
2
Skid board
A
D
C
E
B
Verify Square, Level and Plumb