How to Guide

ManualsBrandsJELD-WEN ManualsPatio DoorsClear Glass Brilliant White Clad-wood Right-hand Double Door Sliding Patio Door (Common: 72-in x 80-in; Actual: 71.25-in x 79.5-in)

Multi-Point Sliding Door Handle Set Replacement

When removing screws and parts, keep track of their exact locations for

reinstallation. To replace, follow instructions included with the new handle

set. Compare replacement components to existing hardware to verify you

have the correct replacement part(s).

1. Open panel.

2. Loosen set screw

with 4mm allen

wrench from interior

or exterior handle

(only one handle,

notboth).

3. Remove handles.

Note! One handle

will remain attached

to the spindle bar.

4. Slide spindle bar

and other handle

out ofpanel.

5. Remove the screw

in the panel edge

to remove the dead

bolt latch if present.

If there is no

attachment screw,

the dead bolt latch

is xed to the faceplate and will remove with it.

6. From the interior, unscrew and remove both face plates (they are

connected with the same screw).

7. Unscrew and remove the locking mechanism.

8. To install, reverse these instructions.

Multi-Point Sliding Lock Adjustment

Note! This procedure only applies to doors with a continuous strike

plate. For all others, or for help identifying your specic product,

please contact us.

1. Insert the guide pin

that came with the

door (or available

from your supplier)

into the hole in the

locking mechanism

above the latch.

Screw it in by hand.

2. Gently close the

door. The guide

pin should enter

a keeper hole in

the keeper. If not,

loosen the screws

in the keeper and

move the keeper up or down to align with the guide pin. Compare

replacement handle set or lock to your existing hardware to make sure

you have the correct new hardware. When removing screws and parts,

keep track of their exact locations for reinstallation.

W-2500 Sliding Door Handle and Lock Replacement

Compare replacement handle set or lock to your existing hardware to

make sure you have the correct new hardware.

When removing screws and parts, keep track of their exact locations

forreinstallation.

1. Open panel.

2. Remove screws from

the interior handle.

3. Remove handles

(interior and

exterior), the interior

lock lever and the

exterior keyway lock

(if applicable).

4. Remove the

attachment screws

from the lock

assembly in the

dooredge.

5. Remove the

lockassembly.

6. To remove the lock

strike, mark the

current location

in the jamb

and remove the

attachmentscrews.

7. To install, reverse

these instructions.

Lock Adjustment

Make horizontal

adjustment as follows:

1. Open panel

and locate the

lockassembly.

2. Use a small

screwdriver to turn

the adjustment

screw located on

the face of the lock.

3. Turn the screw

counterclockwise to

reduce the length of

the latch hook. Turn screw clockwise to lengthen the latch hook.

Make vertical adjustments as follows:

1. Loosen the strike screws.

2. Adjust the strike up or down to align with the latch hooks and

retightenscrews.

Multi-Point Sliding Door Handle and Lock

Mechanism Replacement

Multi-Point Sliding Door Lock Replacement

Guide

Dead bolt

screw

Set

screw

Spindle

bar

Face

plate

Locking

mechanism

Dead bolt

latch

Handle

Set

screw

Handle

Latch

Face

plates

Spindle

bar

Adjustment

screws

Attachment

screws

Attachment

screws

Lock

hook

Handle

lever

Interior

handle

W-2500 Handle and Lock Assembly

W-2500 Lock Strike

Product Guide

Wood Patio Doors (JPG012)

05/19

HARDWARE REPLACEMENT AND ADJUSTMENT - CONTINUED