How to Guide

Custom and EpicVue
™
(1996-present)
Removal
1. Unscrew and remove
the exterior side and
head ller located on
the exterior track of the
operating panel side and
head jamb.
2. Unscrew the stationary
panel clip in the head
jamb located at the top
of the stationary panel.
This clip was concealed
by the exterior head ller.
3. Remove the screws in the
sill ller on the interior
side of the stationary
panel.
4. Use a putty knife to
remove the interior side
ller. The interior side
ller is nailed at 18"
intervals with two, side
by side nails at each
location.
5. Cut the sealant joint
between the stationary
panel and the side jamb.
6. Slide the stationary panel
towards the center of the
unit and remove.
7. To reinstall the panel,
perform these steps in
reverse order.
Norco Sliding StationaryPanel
From interior:
1. Remove operating
panel.
2. Unscrew and
remove head and
sill brackets. For
the sill brackets,
remove only the
screws on the panel
end of the brackets.
Norco doors (pre
1995) use a "W"
bracket fastened to
the side jamb and
interior face of the
stationary panel.
From exterior:
3. Slide panel away
from side jamb
while supporting
it on both sides.
Siteline panels
must be slid all
the way toward
the operating
paneljamb.
4. Lift and swing bottom of panel to exterior and remove.
5. To reinstall the panel, perform these steps in reverse order.
W-2500 and Caradco Sliding Stationary Panel except French Manor
From interior:
1. Remove operating panel.
2. Unscrew and
remove head and
sillbrackets.
3. Unscrew and
remove security
angles (the brackets
fastened to the sill
and interior face
(shown) or edge
ofthe panel).
4. Unscrew and
remove aluminum
interlock.
5. Remove screws from
around panel (these
screws are visible
and go through the
vinyl stop around
the interior side of the stationary panel).
From exterior:
6. Slide panel away from side jamb while supporting it on both sides.
7. Lift and swing bottom of panel to exterior and remove.
8. To reinstall the panel, perform these steps in reverse order.
Interior
Sill
ller
Exterior
side ller
Exterior
head ller
Clip
Frame
Sealant
Interior
side
ller
Panel
Head
bracket
Sill
brackets
Exterior
Interior
Aluminum
interlock
Head
bracket
Sill
bracket
Stationary Panel Removal- For Professionals Only
Pozzi (Pre-1996)
Note! Operating panel must be removed rst. The head stop should
already be removed.
From interior,
1. Unscrew and remove the
head ller from operating
panel side of headjamb.
2. Unscrew and remove the
head and sillbrackets.
3. Slide panel away from
jamb, press bottom
towards exterior while
lifting up, then remove to
interior.
4. To reinstall the panel,
perform these steps in reverse order.
Exterior
trim
Head
stop
Operating
panel
Head
ller
Product Guide
Wood Patio Doors (JPG012)
05/19
5
SLIDING/GLIDING PATIO DOOR PANEL REMOVAL AND INSTALLATION - CONTINUED