How to Guide

Single and Multi-Point Swinging Door 90
o
Turn Cylinder
Removal
1. Remove cylinder screw.
2. Loosen set screw on
knob and remove knob
from body ofcylinder.
3. The arrow and drive
tab must be pointing
down. If the tab
cannot be rotated to
this position, push the
pin down with the ring
wrench to disengage
the stops and turn the
cylinder shaft until the
arrow and drive tab is
pointingdown.
4. Hold the cylinder shaft in this position and remove the cylinder body
from the door.
Installation
1. Loosen set screw on knob and remove knob from body of cylinder.
2. The arrow and drive tab must be pointing down to install the cylinder
into the lock mechanism If the tab cannot be rotated to this position,
push the pin down with the ring wrench included to disengage the
stops and turn the cylinder shaft until the arrow and drive tab is
pointing down.
3. Hold the cylinder shaft in this position and insert the cylinder body into
the door so the tab on the cylinder is inside of the lock.
4. Rotate the shaft that the thumb turn attaches to so that the top of
the post moves toward the edge of the door or insert the key into the
cylinder and rotate so the top of the key moves towards the edge of
the door This will extend the deadbolt If the post or key is rotated the
wrong direction, it will rotate approximately 120
o
and lock up where it
cannot be rotated in either direction. If this happens, push the pin down
with the ring wrench included to disengage the stops and turn the key
in the opposite direction until the deadbolt extends.
5. Fix knob horizontally on cylinder shaft with set screw hole on
thebottom.
6. Tighten set screw and install cylinder screw.
Swinging Patio Door Lock Handing Change
Change handing if the lock latch is not facing the right direction for your
patio door. To determine handing, hold locking mechanism up to the
active panel in correct position. If the at side of the latch is facing the
jamb, change the handing.
Caradco French Manor/French View and W-2500
For the French Manor, if you need to change the handing, you will need a
new astragal assembly and sweeps. For the French View, you will need a
new astragal assembly. Call us to order.
1. Locate latch release
on side of mechanism
behind the latch.
Depending on the
door model, it will
either be a set screw
or a metallever.
2. If the latch release is a
set screw, remove set
screw from hole in side
of mechanism (may be
clearly marked) with
2mm or 5/64" Allen
wrench. Remove lock
latch, rotate 180°,
andreinsert.
3. If the latch release is
a metal lever, insert
small screwdriver in
slot and move metal
lever as shown. Latch
should pop out. With
ngers, rotate latch
180°, and press back
into place until latch
automatically locks
back in.
Norco And Siteline
Single point and Multi-
point handing can be
changed by simply
pulling the tapered
latch out slightly and
rotating180º.
90
o
Turn Cylinder for Swing Doors
Key
Cylinder
Cylinder
shaft
Knob
Pin
Drive
tab
Ring
wrench
Set
screw
Set screw
hole
Latch
Set
screw
Handle
Latch
Face
plates
Spindle
bar
Latch
Metal lever
Product Guide
Wood Patio Doors (JPG012)
05/19
11
HARDWARE REPLACEMENT AND ADJUSTMENT - CONTINUED