Instructions / Assembly

06/15/18
Assembly and Installation Instructions
for F-2500 Fiberglass Folding Patio Doors (JII-90008)
13
INSTALL PANELS
10
Install Panels
Study the overall door conguration before installation. Begin panel
installation from the pivot panel. Panels are labeled “Pivot Panel” and
”Handle Panel”.
NOTE: Some hinge screws
are pre-installed in the edge
of the panels that have
ush bolts. These screws
are shorter than the other
hinge screws and must
be removed to install the
hinge and then re-installed
in the same location. This
is to eliminate interference
between the hinge screws
and ushbolt.
PIVOT PANEL: Installation of Wall Pivot Hardware - Box 1
1. Install Lower Wall Pivot
Hinge Leaf - Box 1 on
lower end of panel with
provided #10x1-1/2" at
headscrews.
2. Hold the door in the vertical
position. Lift, align and then
set the Lower Wall Pivot
Hinge Leaf - Box 1 onto
the Lower Wall Pivot Pin
- Box 1 installed into the
sill. Ensure the panel does not make contact with the head of the door
frame during process. With the door panel supported, rotate to the fully
openedposition and hold until upper wall pivot hinge leaf is secured.
3. Slide the Upper Wall Pivot
Hinge Leaf - Box 1 on the
Upper Wall Pivot. Secure the
Hinge Leaf to the edge of
the pivot panel.
HANDLE PANEL: Installation of Directional Carrier Hardware - Box 3
1. Hold the pivot door panel in the open position. Place the handle panel
next to the pivot panel.
2. Make sure the center Pull Handle - Box 2 is to the inside. Secure Hinges
- Box 2 with the provided #10 x 1-1/2" at head screws.
3. Attach the pivot panel to the directional hardware installed in the frame
Top Directional Guide - Box 3 and the Directional Carrier Set (two
wheel) - Box 3.
Handle
panel
(2nd)
Handle
panel
Pivot
panel
(1st)
Pivot
panel
Hinge with
4 pre-drilled
holes
Hinge leaf with
3 pre-drilled
holes
Interior side shown
Exterior side shown
Panel
Lower wall
pivot hinge
leaf
Lower wall
pivot pin
Upper
wall pivot
Interior
Screws into
wood rst
1
1
2
2
Hinge
screw
Top Directional Guide -
Box 3
Directional Carrier Set
(two wheel) - Box 3
PIVOT PANEL: Installation of Intermediate Hinges - Box 2
1. Attach the hinges to the pivot panel with the provided #10x1-1/2" at
head screws. Use the 3 pre-drilled holes on the pivot panel to align the
hinges (the handle panel will be pre-drilled to accept the remaining hinge
leaves).
NOTE: Make certain that the countersunk holes for the screw heads on
the hinge leaf are facing toward the exterior.