Instructions / Assembly

06/15/18
Assembly and Installation Instructions
for F-2500 Fiberglass Folding Patio Doors (JII-90008)
12
HARDWARE INSTALLATION
9
Install Hardware
1. Arrange hardware so that it matches the hardware layout within the
schematic on page 8.
2. To avoid damage to the rollers, clean all debris from the head and
silltrack.
3. Locate the cut out near
the end of the sill track
and insert the properly
handed Directional
Carrier Set (two wheel)
- Box 3. Carriers should
be positioned so that
the tapered wheels face
towards the interior and
the horizontal wheels face
towards the exterior.
4. Insert the properly handed
Lower Wall Pivot - Box1.
Hinge should be inserted so
that the heel, with the two
screw holes, is towards the
interior of the sill track. Slide
all the way against jamb.
NOTE: The hardware in
box1 includes two plastic
housings for the Lower
Wall Pivot (one for a left
hand door and one for a
right hand door). Make sure
the correct plastic housing
is used according to the
handing of the door.
Secure the Lower Wall
Pivot - Box 1 to sill track
with two #6x1"screws.
Apply the aluminum sill
cover plate on top of the
Lower Wall Pivot - Box1
and secure with two #8
x3/8" screws.
5. Locate the cut out near the
end of the head track and
insert the Top Directional
Guide - Box 3.
NOTE: Partial removal of the
head jamb weatherstrip (just
past the cutout in the head
jamb) will assist with the
Upper Wall Pivot installation.
6. Slide the Top Directional
Guide - Box 3 to the
opposite end of the head
track.
7. Install the Upper Wall Pivot
- Box 1. Align the metal
hinge plate with the plastic
housing and secure the
hinge to upper track with
four #6 x 1" screws.
8. Press the weatherstrip back
into the headtrack.
Cutout
Lower
Pivot Cover -
Box 1
Cutout
Weatherstrip
Top
Directional
Guide - Box 3
Upper Wall
Pivot -
Box 1
Weatherstrip
Head
Exterior
Exterior
Exterior
Exterior
Directional
Carrier Set -
Box 3
Lower Wall
Pivot - Box 1
Sill