Instructions / Assembly

06/15/18
Assembly and Installation Instructions
for F-2500 Fiberglass Folding Patio Doors (JII-90008)
11
FRAME INSTALLATION AND FASTEN FRAME CONTINUED
8
Install Frame
WARNING! To avoid injury, use at least two people to install.
1. If installing a job site
fabricated sill pan, run a
continuous 3/8" bead of
sealant along the sill pan
back dam. When the frame
is installed, make sure the
frame makes solid contact
with the sealant. Add more
sealant if necessary.
2. Tilt the frame into the rough opening. Install temporary fasteners through
head track to adequately support frame until fully installed.
SHIM THE JAMBS
NOTE: Secure all shims with sealant if necessary.
1. From the interior, shim the
side jambs at each pre-drilled
hole or at maximum 16" on
center. Shim head track next
to pre-drilledholes.
2. Inspect the frame for square,
level and plumb (remove and
reinstall ifnecessary).
Sealant
6"
6"
Interior
Fasten Frame
1. To secure the head, fasten
through each pre-drilled
hole using #10 x 2-1/2"
at head screws. Fasteners
should not go through
shims, but next to shims.
Move shims accordingly to
be next to fastenerholes.
2. To secure the sill, put
a generous amount of
silicone sealant in each
pre-drilled hole and drive
a #10 x 2-1/2" at head
screw (wood oors only,
for concrete oors, see the
Needed Materials section for
masonry fasteners) through each hole.
3. Secure the side jambs
through each pre-drilled
hole using #10x2-1/2" at
head screws.
4. Apply the pre-t weatherstrip in both side jambs, head and sill.
Main roller track
fastener locations
Top track
fastener locations
Side jamb
Weatherstrip
Weatherstrip
Weatherstrip
Head jamb
Sill