Instructions / Assembly

06/15/18
Assembly and Installation Instructions
for F-2500 Fiberglass Folding Patio Doors (JII-90008)
10
FRAME ASSEMBLY
FRAME INSTALLATION AND FASTEN FRAME
7
8
Prepare Frame
If holes are not pre-drilled in the frame components, pre-drill side jamb
holes behind the weatherstrip 4" from the corners and then every 16" on
center. Pre-drill the head and sill tracks 4" from the corners and every 8" for
the span of pivot panel(s). Remaining holes should be 16" on center for the
entire track span.
Assemble Frame
1. On a clean and at surface, carefully position head, jambs and sill with
the interior facingdown.
Brick Veneer Door Install
Sill
Jamb
Sealant
Sealant
Sealant
Filler
Trim
Continuous Interior
Air Seal
Continuous Interior
Air Seal
Backer Rod
and Sealant
Backer Rod
and Sealant
Rigid Flashing
Brick Veneer Door Install - Horizontal View
Brick Veneer Door Install - Vertical View
Building Wrap
Brick
Sheathing
Rigid Flashing
Sill Pan
2 x 4
2 x 4
Trim
Trim
Filler
Drywall
Sealant
2. Run a bead of sealant on
all surfaces of both ends of
the sill as shown. Remove
backing paper from gaskets
applied to jambs. Repeat
application for the head
where the ends will contact
the jambs.
3. Clamp the frame corners
together to ensure the frame
sits ush with the head
and sill. Secure through
the pre-drilled holes in the
jambs with the provided
#10x2-1/2" at head screws.
2x4 Door Install - Horizontal View
Continuous Interior Air Seal
Filler Filler
Building
Wrap
Building
Wrap
Stucco Stucco
Sheathing Sheathing
Trim Trim
2 x 4 Door Install
2x4 Door Install - Vertical View
Building Wrap
Stucco
Sheathing
Drywall
Filler
Trim
Trim
Sill Pan
Sealant
2 x 4
Continuous
Interior Air Seal
Backer Rod
and Sealant