Installation Instructions

ManualsBrandsJELD-WEN ManualsDoorsW5500 Series 22-1/8" W x 36-3/4" H Clad Pine Double Hung Window - White/Natural Pine

INSTALLATION INSTRUCTIONS

for Wood/Clad Wood Windows with Exterior Trim or Nail Fin (JII024)

FLASH WINDOW - WINDOWS WITH A NAIL FIN INSTALLED INTO STUD-FRAMING ONLY

SPRAY ADHESIVE/PRIMER

Spray adhesive/primer may be

required in certain situations,

refer to manufactuer's

instructions for appropirate

applications. Protect window

from overspray and apply

spray adhesive according to

instructions on the product to

nailing n and building wrap

around the window as shown.

APPLY THE SELF-ADHERED FLASHING

Note! Keep the edge of the self-adhered flashing as close to the

window frame as possible and apply over the nail fin.

Note! The following

dimensions are based on 4"

wide tape, adjust accordingly

for wider tape.

1. Apply the side pieces

starting 3" above the header

and overlap the ashing on

the sill as shown.

2. Install drip cap if required.

Pre-drill through the nailing

n if required.

3. Center and apply the header

piece above the header,

overlapping the side pieces

as shown.

4. Press the ashing down with

a J-roller, being careful to

remove any gaps or bubbles

beneath self-adhered

ashing (remove and

replace if necessary).

Cut pieces of self-adhered ashing as follows:

MIN. SIZES OR

OTHER SPECIFIED

PG50 or below

(4" flashing)

Above PG50

(6" flashing)

One header piece 10" longer than the

header

14" longer than the

header

Two side pieces 8" longer than the

jamb

12" longer than the

jamb

Flashing