Installation Guide

INSTALLATION INSTRUCTIONS
for Bifold Doors (JII103)
8
INSTALLATION FOR TYPE E
7
PARTS INCLUDED
A. Upper pivot plate (2)
B. Hanger
C. Snugger
D. Knob
E. Lower pivot pin
F. Lower bracket
G. Top pivot bracket
H. Aligner
I. Track
J. Adjustment wrench
Screws (not shown)
1. Fasten the pivot
plates to each door
panel with the 1¼"
pan head screws
in the locations
shown. Use the 1"
at head screws on
the lower pivot pin.
Center each plate on
thepanel.
2. Trim track to t
nished opening.
3. Install top pivot
bracket into one end
of the track with
the pin toward the end and 2-1/4" in. From the other end, install the
hanger and snugger (with rubber bumper toward hanger) intotrack.
4. Position overhead
track in the opening
with the open
side down and the
bracket end toward
the jamb. Allow 3/4"
between the front of
the opening and the
track and drive the
provided 1-1/4" pan
head screws through
the pre-drilled holes
until snug. Position
the lower bracket
on the oor in line
with overhead track.
Fasten to the jamb with a 1-1/4" at head screw through the middle
of the top slotted hole.
5. Unlock the track
pivot plate by
pulling the latch
away from the
bracket. With the
door assembly
folded, place the
pin from the top
pivot bracket into
the pivot plate on
the pivot door. Slide
the pin into the
pivot plate and slide
the latch to lock the
pivot plate to the
bracket. Verify the
pin is secure. In the
same manner, lock
the hanger into the
pivot plate on the
lead door.
6. On the bottom,
depress the arm on
the lower bracket
and insert the lower
pivot pin.
To adjust horizontally:
7. At the top, loosen
the screw in the
top pivot bracket
and move toward
or away from the
jamb until there
is 1/4" clearance.
Re-tighten. Repeat
the process for the
lower bracket.
To adjust vertically:
8. There should be a
slight gap between
the lower pin and
the bracket. If there is no gap or the gap is too large and allows the
pin to come out of the bracket, loosen the single screw in the bracket
and adjust up or down until there is a small gap and the pin is
engaged in the bracket. When the bracket is properly adjusted, install
the remaining two screws and tighten.
9. Loosen the screw on the snugger and close doors. Move until the
snugger contacts the guide pin. Open doors and move an additional
1/8" and tighten screw. Doors should slightly “snap” shut, but reopen
easily with a tug on the knob.
10. Adjust the snugger by closing doors, loosen screw and slide against
guide in track. Open doors and move snugger 1/8" closer to panels
and tighten screw.
Continue with Section 8, “COMPLETE INSTALLATION.”
Horizontal
adjustment
screw
Lower
pin
Bracket
arm
Gap
Snugger
Pivot door
Lead door
Bottom of
pivot door
Top pivot
bracket
7/8"
2 1/4"
5/8"
7/8"
A
B
C
D
E
F
H
G
I
J
Unlock
Lock
Horizontal adjustment
screw
Track
Center
3/4"
Head
Jamb
Lower
bracket