Installation Guide

INSTALLATION INSTRUCTIONS
for Bifold Doors (JII103)
7
INSTALLATION FOR TYPE D
6
1. If holes are not
drilled in panels,
pre-drill 7/16" in
diameter holes at
least 1-3/8" deep,
1-1/4" from edges
as shown. Tap pivots
into holes with
light hammer blows
asshown.
2. Trim track to t
nished opening
length if necessary.
3. Secure the track to
the head jamb with
the provided #8 x1"
pan head screws
through the pre-
drilled holes.
4. Position the lower
bracket in the jamb,
centered with the
track, and secure
with the provided
#8 x 3/4" at
headscrews.
5. Place the upper pivot
pin into the hole in
the top pivot bracket
and the guide pin
into the track. Lift
the assembly and
place the lower
pivot pin into the
lower bracket. If
installing a four door
system, repeat for
the other assembly.
Check positioning
andoperation.
Two and four panel assemblies should have 1/4" clearance between the
pivot doors and each jamb. Four panel assemblies should be snug at
themiddle.
Door panels should be folded to gain access to the adjustment screws.
In some cases, the doors may need to be removed to properly access the
adjustment screws.
To adjust horizontally:
6. At the top, loosen
the screw in the
top pivot bracket
and move toward
or away from the
jamb until there
is 1/4" clearance.
Re-tighten.
7. At the bottom,
loosen the
adjustment screw
and move toward or
away from the jamb
until doors are plumb
with jamb, then re-
tighten the screw.
To adjust vertically:
8. Lift assembly slightly
and rotate the
adjustment screw
ange to the right
to raise doors,
and to the left to
lowerthem.
9. Loosen the screw
on the snugger and
close doors. Move
the snugger until it
contacts the guide
pin. Open doors and move the snugger an additional 1/8" toward
doors and tighten screw. Doors should slightly “snap” shut, but
reopen easily with a tug on theknob.
SKIP to Section 8, “COMPLETE INSTALLATION.”
A
B
C
D
E
F
G
H
I
Guide
Jamb
side
Upper
pivot pin
Lower
pivot pin
Lower
bracket
Horizontal
adjustment
screw
Vertical
adjustment
screw ange
Bracket
Bracket
Pin
Horizontal
adjustment
screw
1/4"
Pivot door
Lead door
Bottom of
pivot door
Pivot hole
1-1/4"
1-1/4"
PARTS INCLUDED
A. Upper pivot pin
B. Guide for track
C. Snugger
D. Knob
E. Lower pivot pin
F. Lower bracket
G. Aligner
H. Track
I. Adjustment wrench
Screws (not shown)