Instruction Manual

INSTALLATION INSTRUCTIONS
for Retractable Patio Door Screens (JII030)
3
5. Repeat for the top
track.
6. Using the screen
housing holes as
a guide, drive the
3" screws into the
accessory groove in
the head and sill of
the door frame.

housing end of both

pan head screws. Do

1. Position screen
housing over the
interlock next to
track ends with the
end cap tabs toward
the screen tracks.
2. Trim the
weatherstrip on
the bottom so that
it will t over the
frame and allow
the screen housing

bottom of the sill.
3. Align the bottom
end of the screen
with the bead on
the bottom track
and slide the screen
onto the track.

end cap tab into
the track until the
housing is against
the track.

3
Operating
panel
Fixed
panel
Screen
housing

tab
Screen
housing

track bead
6. Align top track
end cap with the
exterior of the door
frame.

drilled holes in the
track as a guide,

head screw into the
accessory groove at
only the jamb end.
The screen housing
end should remain
unsecured until the
housing is installed.

2
1. Snap one groove
ller shim into the
accessory groove


interlock. The
extended leg of
the shim should be
facing downward
and even with the
bottom of the sill.
2. Place an end cap
on the jamb end of
each track. Align
the end cap with
the exterior of the
door frame.
3. Hold rmly in place until installation is complete.

head screw into the accessory groove at the jamb end and center of

5. Snap groove ller shims into the head of the vinyl frame in the same
manner as the sill.
Accessory
groove
Jamb

ller shim

Top
track

track

caps