Instruction Manual
INSTALLATION INSTRUCTIONS
for Retractable Patio Door Screens (JII030)
2
PRE-DRILL TRACKS
Note! Laying the
tracks on a scrap piece
of wood will make it
easier to drill through
both sides of the
track.
1. Measure 1/2" from
the cut ends of top
and bottom tracks
and mark on the
scribe line.
2. Drill a 5/32" hole
through both sides
of the tracks at each
mark.
1
Note! Tracks are sized for 72" x 80" doors and will need to be cut to
t 60" x 80" units. Installations of 72" x 80" units can skip to section 2,
“INSTALL TRACKS.”
CUT TRACKS
Note! The cut end of
the tracks will vary
based on the handing
of the door. When
cutting the tracks, it
is recommended to
cut the end that will
be at the jamb, or
opposite the screen
housing because it
will later be covered
with an end cap.
1. With a hacksaw, cut
6" off of the jamb
end of the top track
and le any rough
edges smooth.
2. The bottom track
3" off of each end.
3. Place an end cap on the exposed jamb end of each track.
Scribe
Shown
1/2"
1/2"
Top
track
caps
track
A
D
F
INCLUDED PARTS
A Screen housing and weatherstrip
D Track end caps
F Magnetic catch assembly
Items not shown:
NEEDED TOOLS
(optional)
60" DOOR INSTALLATIONS
tracks and magnetic catch.