Owner manual

INSTALLATION INSTRUCTIONS
for Wood Double Hung Sash Replacement Kits (JII028)
4
INSTALLSASHES-CONTINUED
4
COMPLETE INSTALLATION
5
INSTALL LOWER SASH
To install the lower sash,
repeat the steps to install the
upper sash except insert the
pivot pins into the jamb liner
track nearest the interior.
3. If the sash has retainer latches, pull them both toward the center and
tilt the sash up into place.
4.Ifthesashdoesnothaveretainerlatches,simultaneouslypress
against both jamb liners and tilt the sash up into place.
5. Make sure the sash is positioned properly on the same track as the
pivot pins.
6.Slidethesashallthewaydown.Testsashforproperoperationand
remove and reinstall if necessary.
INSTALL HEAD JAMB COVER
1. With the weatherstrip
facing the exterior, position
the wood head jamb cover
horizontally between the
jamb liners on the inside
tracks. If the cover is not
proled on the ends, it
can be trimmed to t if
necessary. Slide the cover
all the way to the top and
check for proper t. The
weatherstrip should be
slightly compressed by the
upper sash when closed.
2. After making any necessary adjustments, remove the cover and apply
a1/8"beadofsealantacrosstheuppersurfaceoftheheadjamb
cover. Press the cover in position against the head jamb and secure
with nishing nails.
Pleasevisitjeld-wen.com/resourcesfornishinginstructions,warranty
and care and maintenance information.
Thank you for choosing
©2010JELD-WEN,inc.|JELD-WEN,theJWiconandReliabilityforreallifeareregisteredtrademarksofJELD-WEN,inc.,OregonUSA.
All other trademarks are the property of their respective owners.
(11/10)
•Closebothsashesandtestthelocktomakesurebothsashesarein
the correct alignment.
•Applyabeadofsealantalongtheinteriorsideofthejambliners.
Head cover
•Reinstalltheoriginalinteriorstopsandtrim,orreplacewithnew
millwork.
•Finishanyexposedwoodsurfaces.Aluminumcladdingdoesnot
require additional nishing.