Instructions / Assembly

INSTALLATION INSTRUCTIONS
for Pre-Hung Exterior Entry Doors (JII106)
3
REMOVE PACKAGING
Remove shipping materials such as corner covers, shipping blocks
or pads. Remove any staples exposed on the frame, but leave glass
protective lms.
1. If the door
unit includes
packaging under
the threshold
and bottom end
of the side jamb,
remove it. If the
door comes with
a security plate on
the outside of the
frame at the latch,
DO NOT remove
it. Install the door
with the security
plate attached.
2. Ifthedooris
fastened closed
with a duplex nail,
removable plastic
plug, or a shipping
strap, remove
these along with
the packaging and
crating.
1
REMOVEPACKAGING&INSPECTDOOR
Note! If the door has
pre-hanging clips, DO
NOT remove them
until instructed to
do so. These clips
hold the door system
aligned and closed
during installation.
INSPECT DOOR
•Cosmeticdamage
•Productsquareness(diagonalmeasurementsmustbewithin1/4"
difference)
•Correctproduct(size,color,gridpattern,handing(sidethehingesare
on),glazing,energy-efciencyrequirements,etc.)
If any of the above conditions represent a concern, or if you expect
environmental conditions to exceed the door's performance rating,
donotinstallthedoor.Contactyourdealerordistributorfor
recommendations.
Shipping strap
Shipping strap
Security plate
NEEDEDMATERIALS&TOOLS-CONTINUED
•Cuttingshears(sillpan)
•Tapemeasure
•Utilityknife
•Level(4ft.minimum
recommended)
•J-roller
•Caulkinggun
•Drillwithbits
•Constructionstapler
•Hammer
•Phillipsscrewdriver
•Nailset
•Square
TOOLS