Instructions / Assembly

INSTALLATION INSTRUCTIONS
for Vinyl Patio Doors with Integral Nailing Fin (JII006)
4
INSTALL SILL PAN
4.Placethesillpanin
the rough opening.
5.Applyspray
adhesive/primer to
the sill area. Follow
manufacturer's
instructions
for application
methods.
6. Cut a piece of
JELD-WENself-
adhesive ashing
the length of the sill
and apply over the
sill pan as shown.
The bottom of the
sill pan should be
completely covered
by the self-adhesive
ashing.
9. Sealbackcorners
of sill pan with
sealant.
10. For step-down
landings only, cut
plastic drain screen
to length of
sill + 2" and staple
1/2" below sill
edge. The drain
screen provides
a path for air to
dry any incidental
moisture in the
rough opening.
PREPARE SILL (CONTINUOUS SLAB ONLY)
3.Markalineinthe
rough opening
across the front and
back of the sill pan
as shown. Remove
sill pan and apply
three beads of
sealant between the
marked lines.
FOR RETROFIT INSTALLATIONS
After removing the old patio door, remove sufcient siding to expose at
least9"ofintactbuildingwrap.Ifdamaged,applynewbuildingwrap
in a shiplap manner. Verify trimmer studs and header are structurally
sound. Continue with the instructions.
PREPARE BUILDING WRAP
1. Trim building wrap
ush with the
edges of the rough
opening. Verify
this does not void
manufacturer’s
warranty.
2. At the head, slit
building wrap 6"
at45°.Tapeupas
shown.
4
PREPARE ROUGH OPENING
Sealant
45˚
6"
S
p
r
a
y
A
d
h
e
s
i
v
e
6"
3"
7. Cuttwopiecesof
JELD-WENself-
adhesive ashing
6" wide and the
sillpanwidth+3"
long.
a. For continuous
slab landings
only, cut out the
inside corner.
Sill
pan
width
6"
3"
Discard
(for
continuous
slab only)
Self-Sealing Corner Flash
Sill
pan
width
3"
6"
Discard
(for
continuous
slab only)
Sill pan
width
3"
3"
Continuous Slab Landing
Sill pan
width
3"
3"
Step-Down Landing
Sill pan
width
3"
3"
Sealant
1"
1/2"
b. Adhere the
pieces of
ashing to the
inside corners.
8. Smooth gaps or
bubbles beneath
self-adhesive
ashing with a
J-roller (remove
and replace if
necessary).