Instructions / Assembly

INSTALLATION INSTRUCTIONS
for Vinyl Patio Doors with Integral Nailing Fin (JII006)
7
PATIO DOOR ADJUSTMENT
Roller Adjustment
Note! Adjusting door
too high may allow
water and air leakage.
Adjust rollers just high
enough to clear sill
track.
1. Builders doors have
an adjustment
screw on each
lower end of the
operating panel(s).
Premium doors
have access holes
on the face of each
lower end of the
operating panel(s).
Remove small vinyl
plugs from each
hole (if present).
2. Open operating
panel enough to
compare with
frame jamb.
Lock Adjustment
Note! If the strike
plate was not
previously installed,
line up the screw
holes with the dimples
in the operating panel
side jamb and drive
screws through the
two slotted screw
holes.
If the lock does not
properly engage the
strike plate:
•Loosenthestrike
plate screws and
move up or down
until the latch
engages properly.
If the door does not
lock or is loose when
locked:
•Turnthelatch
adjustment
screw(s) in 1/2
turn increments:
clockwise to loosen
or counterclockwise
to tighten. Premium
doors have a double
latch and two
adjustment screws.
7
COMPLETE INSTALLATION - CONTINUED
Premium Patio Door
Builders Patio Door
Note! Builders roller adjustment screws are in close proximity to the
attachment screw. Adjust only the lower screw (as shown); loosening
the attachment screw will detach the roller from the operating panel.
3.Usinga#2Philips
head screwdriver,
turn the adjustment
screw clockwise to
raise the panel, and
counterclockwise to
lower the panel.
4.Adjustasneeded
until interlocks, grid
patterns, and jambs
line up.
5.Testtheoperating
panel for proper
operation.
6. Re-apply the small
vinyl caps over the
roller adjustment
screw holes if
applicable.
Attachment
screw
Adjustment
screw
Lower panel
Raise panel
Builders Roller
Premium Patio Door
Lock hook
adjustment screw
Lock hook
adjustment screw
Builders Patio Door
Lock hook
adjustment
screw
Strike
plate