Installation Guide

ASSEMBLY AND INSTALLATION INSTRUCTIONS
for Premium Aluminum and Premium Atlantic Aluminum Sliding Patio Doors (JII020)
7
SECURE STATIONARY PANEL(S)
On units with a
stationary panel in
the exterior track, the
xed “O” panel will
need to be secured.
•Workingfromthe
inside, slide the
stationary panel into
the jamb pocket (in
a closed position).
•ForDP50/DP80
units, secure using
offset T clips located
at the head and
sill, 6" from the
jamb as shown.
First, screw the clips
into the stationary
panel pocket at
the head and sill.
Then, secure the
other end of each
clip to the interior
sideofthepanel;
seal screw points
with polyurethane
or100%silicone
sealant.
SECURE STATIONARY PANEL(S) - CONTINUED
•ForDP20units,
secure with 3 screws
through the jamb
into the panel
frame using #8 x
3/4" self tapping
screwsasshown;
seal screw points
with polyurethane
or100%silicone
sealant.
INSTALLPANELS-CONTINUED
6
INSTALL EXTERIOR PANEL(S)
•Insertexterior
panels, making sure
the panel interlock is
facing the interior.
•Placetheslotofthe
panel head over the
middle guide leg of
the frame head.
•Raisethepaneland
swing the bottom
in so the wheels are
properly located
over the track.
ADJUST ROLLERS
Lift each panel and
adjust the rollers
with a #2 Phillips
head screwdriver by
turning the bottom
screw on the ends of
both panels. Do not
use a power driver. All
door panels, including
stationary panels,
have wheels that need
to be adjusted. Adjust
door to ensure jambs,
interlocks and grid patterns line up.
Note! Turn clockwise to raise the panel, counterclockwise to lower
the panel.
Clip
Clip
Screw
DP 20 Door (Interior)
Screw
DP 50/DP 80 Door (Interior)
For xed panels on the interior track, screw through the face of the
jamb on the interior side of the door, through the xed panel, securing
the panel in place.
Bumper(s) must be installed 6" from each jamb in the head track behind
operating panel(s). Secure in place using frame installation screws to
anchor into the building structure.
An additional bumper must be installed on the secondary operating
panel of any set of stacking panels.
6"
Bumper(s)
Fixed
panel
Primary
operating
panel
Secondary
operating
panel