Installation Guide

ASSEMBLY AND INSTALLATION INSTRUCTIONS
for Premium Aluminum and Premium Atlantic Aluminum Sliding Patio Doors (JII020)
5
INSTALL SILL PAN
•Setthesillpanin
place pressing it
down  rmly into
thesealant.Usea
J-roller if necessary
to ensure a smooth,
secure seal.
•Applya3/8"
continuous bead of
sealant across the sill
pan back dam.
•Forstep-down
landing apply a layer
of liquid  ashing
across the lower
lip of the sill pan,
joining it to the face
of the foundation.
PREPAREROUGHOPENING
4
PREPARE BUILDING WRAP
(For masonry/block
wall construction, skip
to PREPARE SILL PAN)
•Trimbuildingwrap
 ush with the
edge of the rough
opening at the head
and sides. Trim  ush
at the sill for step-
down landings.
•Atthehead,slit
building wrap 6"
at 45°. Tape up as
shown. Also pull
back building wrap 6" away from jambs and tape up as shown.
PREPARE SILL PAN
(For a recessed sill pocket, skip to COMPLETE OPENING PREP)
•Cutapieceofsheet
material to the
length shown.
•Lightlycrease
folding lines 1/2" in
from the two short
sides and one long
side.
•Measurethewidth
of the exterior edge
of the frame and
add9/16".
•Takethisdistance
from the back edge
of the sheet material
and lightly crease a
folding line.
•Cut1/2"inatthis
line on both sides of
the sheet material.
•Foldthethreeback
sides up to make a
3-sided box.
•Forstep-down
landings, fold the
front  ap down. For
continuous slabs,
remove the front
 ap.
6"
45°
6"
6"
Measure
frame
width
Frame
width
+9/16"
Length of rough opening sill plus 1"
1/2"
1/2"
Fold sides and back up
Fold corner
forward
Fold front
 ap down
PREPARE SILL
•Setthesillpanin
place and mark a
line across the back
of the sill pan with
a pencil as shown.
Remove sill pan.
•Applythree3/8"
beads of liquid
 ashing between
the marked line and
the exterior edge of
the rough sill.
Liquid
 ashing
Sealant
COMPLETE OPENING PREP
Waterproof the rough
opening with one of
the following methods:
•Wrapthebuckor
stud completely with
self-adhesive  ashing,
then seal the joint
between the  ashing
and the structure,
and at the corners as
shown.
OR
• Applyliquidapplied
 ashing in a smooth
1/16" thick layer
covering the exterior
face of the structure
in a 6" width. Apply
1/16" thick layer
to cover the entire
surface of the head
and jambs, extending
onto the sides of the
sill pan or across the
entire surface of the
sill pocket.
Liquid
 ashing
For continuous
slab, remove  ap
Sealant
Self-
adhesive
or liquid
 ashing
Self-adhesive
 ashing
Sealant