Installation Guide

INSTALLATION INSTRUCTIONS
for Aluminum Windows with Nailing Fin (JII004)

INSTALL WINDOW - CONTINUED
5
SECURE WINDOW
Note! Fastener heads must be flush. Do not dent nail fin. The first 12"
beyond mull joints, on both sides, must be fastened through each nail
fin hole with #10 x 1 1/2" truss head screws.
t'BTUFOXJOEPXTSBUFEMFTT
UIBO%1UISPVHIUIFOBJM
åOIPMFTGSPNUIF
corners and 8" apart all the
way around the window.
t'BTUFOXJOEPXTSBUFE%1
or above every 4".
t3FNPWFUIFTIJNTGSPNUIF
side jambs.
APPLY THE SELF-ADHESIVE FLASHING
Note! Keep the edge of the
JELD-WEN self-adhesive
flashing as close to the
window frame as possible and
apply over the nail fin.
1. If installing a window
SBUFEBCPWF%1DFOUFS
BOEBQQMZXJEFýBTIJOH
below the sill.
2. Apply the side pieces
starting 2" above the header
and overlap the drain mat
on the sill as shown.
$FOUFSBOEBQQMZUIFIFBEFS
piece above the header,
overlapping the side pieces
as shown.
4. P ress the ashing down with
a J-roller, being careful to
remove any gaps or bubbles
beneath self-adhesive
ashing (remove and
replace if necessary).
SPRAY ADHESIVE/PRIMER
Apply spray adhesive (protect
window from overspray) as
instructed to nail n and
building wrap around the
window as shown.
FLASH WINDOW - WINDOWS INSTALLED INTO STUD-FRAMING ONLY
6
S
p
r
a
y
A
d
h
e
s
i
v
e
$VUQJFDFTPGTFMGBEIFTJWFýBTIJOHBTGPMMPXT
DP50 or below
(4" flashing)
Above DP50
(6" flashing)
One header piece 10" longer than the
header
14" longer than the
header
Two side pieces 7" longer than the
jamb
10" longer than the
jamb
One sill piece N/A MPOHFSUIBOUIF
sill
Window
Window
Mull joint
Nail n
Y5SVTTIFBETDSFX
4"
4" 4"
8"

2"
Drain mat
Flashing
2"
2"