Installation Guide

INSTALLATION INSTRUCTIONS
for Exterior Door Slabs (JII107)
2


than the slab and

There should be
enough distance
between the jamb
edge and the stop
to accommodate the
thickness of the slab.

jamb is square.

measurements
should be the same.

deviation from

2




C

Verify Square, Level, & Plumb







Professional assistance may be necessary to correct any problems before
installation.

or pads.

1



slab. Contact the supplier for recommendations.
NEEDED MATERIALS








Note! Follow all material manufacturers’ instructions for proper use
and compatibility.

NEEDED TOOLS







roller, spray equipment, masking









3
IMPORTANT: The door slab should be nished (painted or stained) on
all six sides with an equal number of coats after all routing, trimming,
boring and touch-up has been completed and it has been properly t
in the jamb. Failure to nish on all six sides and install into a square,
level and plumb condition could result in denial of warranty claims for
operational or performance problems. See our nishing document at
www.jeld-wen.com for nishing requirements and details.
PREPARE JAMBS AND SLAB

threshold to the bottom of the head and from side to side in several




and the top of the threshold.

