Instructions / Assembly

03/18
Installation Instructions
for Vinyl Windows without Nailing Fin (JII011)
7
INSTALL WINDOW - CONTINUED
4
For WZ3-IMPACT Tilt Single Hung, Tilt Double Hung
and Horizontal Slider Windows ONLY
Additional brackets are applied to the Wind Zone 3 (WZ3) products listed
below. The factory screws must be backed out of the bracket and replaced
with a #8 x 2 1/2" at head screw (stainless steel recommended).
1. Double check that the windows are installed plumb, level and square.
2. Operate the window to verify bracket location is correct and there are
no clearance issue. If a clearance issue is identied adjust brackets as
necessary for proper operation.
3. Remove one of the factory
applied screws. Apply enough
sealant to the bracket hole
to cover the existing screw
hole and so there will be
adequate squeeze out around
the head of the fastener to be
appliednext.
4. Place shim between the
window frame and rough
opening, in-line with the
bracket. Align the shim so that
the fasteners go through the bracket and hold the shim in place.
5. Apply a #8 x 2 1/2" screw
through the bracket hole.
Tighten until snug and squeeze
out is observed around the
screw head. Wipe off excess
sealant and repeat for the
other screw.
6. Repeat for any
remainingbrackets.
Single Hung Double Hung
Horizontal Slider