Torque Converter Conversion Kit 555-60963 1993-2015 4L60E, 4L65E, & 4L70E For use with Non-Lockup Converters ONLY
Introduction Installation (Input Shaft) We would like to take this opportunity to thank you for purchasing this JEGS 4L60E. 4L65E, and 4L70E Torque Converter Conversion Kit. We welcome any comments or feedback you might have. If you have any questions about this product or about the installation procedure, please feel free to contact us at 1.800.345.4545. 1. With a small flat punch and hammer, remove the orifice capsule by hitting the high spot on the capsule shown on the diagram below.
Installation (Input Shaft) Installation (Valve Body) 2. Remove and discard original Lock-up valve and springs. Install NEW Conversion Valve, Pin and Slug as shown. RE-INSTALL THE ORIGINAL WASHER AND RETAINER. 1. Remove and discard the converter regulator valve, spring, and isolator valve. Save the end plug and clip. REMOVE AND DISCARD Type 1 Type 2 NOTE If the snap ring groove is obscured by the washer preventing the retainer from fitting, try the following.