Installation Sheet

WHV10/18 v.1
STEP 5
Wall Stud
Compressed
Plaster
Finished Surface
Horizontal
Header
Compressed
Plaster
Finished
Surface
Wall Stud
Install Wall
Bracket
Level
Non-acidic
Silicone
Non-acidic
Silicone
Level
Wall
Wall
Wall Stud
Compressed
Plaster
Finished
Surface
Align the preinstalled brackets on the back of the vanity to the previously
installed wall brackets and hang the vanity.
STEP 4
To avoid damage, remove cabinet drawers. Then
cover the drawer slides with plastic sheet to prevent
debris from getting into the slides.
STEP 6
Wall Stud
Compressed
Plaster
Finished Surface
Horizontal
Header
Compressed
Plaster
Finished
Surface
Wall Stud
Install Wall
Bracket
Level
Non-acidic
Silicone
Non-acidic
Silicone
Level
Wall
Wall
Wall Stud
Compressed
Plaster
Finished
Surface
Using a non-acidic kitchen & bathroom silicone, install the basin to the vanity base.
STEP 7
The unit must be sealed along the back edge of the
top and down the side against the wall with non-
acidic kitchen & bathroom silicone. Seal around the
cabinet with silicone.
STEP 8
Please note when installing an undermount basin
or counter basin onto a stone top, they must be
siliconed on. When the silicone has dried, ensure
you caulk around the basin and stone top.
STEP 9
The vanity is now ready for plumbing installation.
Care Instructions
Door and Cabinet Care:
Regular cleaning with a damp cloth is sucient.
Never use strong detergents or abrasive cleaners
as this may damange the surface nish of your
furniture.
Glass Care:
When cleaning glass panels or mirrors, use a
cloth with approved window/glass cleaner. Do
not use washing powders or any other substance
containing abrasives, as these will scratch the glass.
Bathroom furniture may deteriorate if subjected to
heavy water spillage or prolonged condensation.
Solid Surface Countertop/Basin Care:
For general cleaning, just use soap and water or any ammonia based household cleaners. For stubborn stains,
use a mild abrasive cleaner or a diluted solution of bleach. To remove light scratches and to renew the nish,
use a combination of mild abrasive and a “Kitchen Scrub” pad or the equivalent pad. Matte Finish: To remove
deep scratches and cuts, use a 600 grit sandpaper equipped in the package using a sanding block. Sand until
the scratch disappears. Be sure to feather out the area so that you do not leave a low spot in your counter top.
Next, restore the nish by using a mild abrasive cleaner and a “Kitchen Scrub” pad or the equivalent pad.