Installation Guide

13
FLOOR-MOUNTED DOOR
GUIDE INSTALLATION
Used for standard doors that are grooved
in the bottom of the panel for the guide.
With the door hanging straight, position the floor-
mount door guide inside groove in the bottom of the
door. Slide the door side to side to ensure the guide
is properly placed. Mark location of the guide.
Attached guide with supplied screws. If needed
supplied anchors can be used by drilling 1/4" dia
holes. (FIGURE 12)
To fasten guide the door may need to be removed or
slide out of the way by loosening one of the stoppers.
If Soft Close units have been installed, refer to Soft
Close instructions for mounting activation brackets.
14
OPTIONAL WALL-MOUNTED
DOOR GUIDE INSTALLATION
The Wall-Mounted Guide can be used if the
floor condition makes it difficult to attach
the floor mounted guide.
Close to the opening, position and secure the wall-
mounted door guide directly into the wall or trim,
extending the guide as necessary to allow the door to
travel side-to-side. Tighten to secure in place.
NOTE: Adjust correctly for 1-3/8" or 1-3/4" thick
doors for smooth opening and closing operation.
To fasten guide the door may need to be removed or
slide out of the way by loosening one of the stoppers.
15
ATTACHING OPTIONAL FLOOR
GUIDES USING SIDE METHOD
For custom doors that are not grooved on
the bottom, the side guides can be used.
Close to the opening, position both the floor-mounted
door guides to allow the door to travel
side-to-side on both sides of the door. Screw into
place directly into the floor.
Note: Measure correctly for 1-3/8" or 1-3/4" thick
doors for smooth opening and closing operation.
To fasten guide the door may need to be removed or
slide out of the way by loosening one of the stoppers.
1/4" (8 mm)
Drill depth
1 3/16"
(30 mm)
Drill depth
1 3/16"
(30 mm)
1/8" (3 1/2 mm)
1/4" (8 mm)
Drill depth
1 3/16"
(30 mm)
Drill depth
1 3/16"
(30 mm)
1/8" (3 1/2 mm)
FIGURE 12. Attaching floor mounted door guide
IF NEEDED
FIGURE 13. Attaching optional wall mounted door guide
FIGURE 14. Attaching optional floor guides using side method
1/8" (4 mm)
Drill depth
1" (25.4 mm)
x2 Floor-mounted bottom guides
x4 #8 5/8" pan head philips screws
Barn Door Installation Guide
BARN DOOR HARDWARE STRAIGHT STRAP KIT
©2017 Masonite International Corporation. HMD-17502 1-800-663-DOOR masonite.com