User manual

9
EN
Safety instructions
Additional requirement for Outer door Installation
Warning before installation
Installation steps(See drawing)
Symbols explanation
Class III appliance
• The rated static load of this product is 5kN after installation. It is not
suitable for installed in carriageways, car parks.
• The rated maximum surface temperature of this product T=65ºC.
• Always disconnect from main
supply before installation,connection
and servicing.
• Repairs should only be carried out
by qualified person and using
genuine spare parts.
• The spot with IR receiver must be
positioned as the first spot in the
installation (closest to the driver). It
is the one receiving the message
from IR Remote Controller.
• The spot with IR receiver is the
one receiving the message from IR
Remote Controller.
WARNING: The installation should conform to the relevant standards.
Should you have any doubt, please seek advice from a professional electrician.
• It is possible to use below type of cable for connection to the main supply:
-Flexible cord type: H05RN-F 2x1.0mm
2
• Maximun 10 luminaires may be inter connected.
• This product must be connected to a circuit protected by a residual current protective
device with rated residual operating current not exceeding 30mA.
• The product is not suitable for working condition below -30 degree centigrade.
• The external flexible cable or cord of this luminair can not bereplaced; if the cord is
damaged, the luminair shall be destroyed.
• The light source of this luminaire is not replaceable; when the light source reaches its
end of life the whole luminaire shall be replaced.
Following Warnings only applicable for kit supplied with LED driver
• These spots can only be connected to the secondary of the LED driver supplied with this kit.
• The LED driver must be connected to the main supply according to regulation in force.
• The LED driver can only be used to supply the spots supplied in this kit. The cables and LED driver
supplied in this kit must not be modified
• The LED driver is protected against short-circuit and overload. In case of short-circuit or overload, the
LED driver stops the electric supply. Once the issue is fixed, the LED driver will start again.