User Manual

10
JREMO 4L
Industrial radio remote controller
CHAPTER 3. INSTALLATION & FUNCTION SETTING
3-2 HOW TO INSTALL JREMO® SERIES TX
3-2-1. BATTERIES
A. Use only rechargeable Li-Polymer Battery, JEICO Pin No. JPTX_SCNE1500
When necessary for replacement as it is already built-in the trasnmitter.
B. Precautions
1. Do not try to replace battery unless not in use for a long time or com-
pletely Discharged as well as of no use.
2. Check the power is normal with green LED light before use.
C. Change of Battery
When found fully discharged and/or worn our battery itself and replace
with new one.
D. When not in use, Press down the EMS button for saving battery life and
when not in use for a long time months or longer then disconnect bat-
tery and place it separately in a cool and safe area.
3-2-2. FUNCTION SETTING & COPYING
In case to change either Tx or Rx, or modify functions its mating transmitter
and receiver must be identical and set both at the same time for sure
identi󽗉cation. Function settings can be done either by the copier or by PC
software, or from direct Rx-Rf at Rx to/from Tx. Either method is an optional.
A. Function set by Copier
1. Unscrew Battery Cap at Tx and Open the top cover at Rx.(Please note
when the Copier to use both Tx and Rx power
should be shut down.)
2. Connect Copier either to Tx or Rx.
3. Follow the instruction of Copier Manual
that will be provided as an optional order.
B. Function set by Software
1. Software can be provided as an optional order
and,
2. It needs another connector (i.e. Gender) with
the software.
C. Direct Copying from Rx
1. Connect Tx and Rx by a connector cable (an
Copier
Gender